Formatting Guidelines

Document formatting
The article should be submitted in the format of a Microsoft Word A4 document (.doc, .docx), without columns, Times New Roman font, 14 pt, 1.5 spacing, all margins 2 cm.
After the article passes the review stage, our editors will independently format the manuscript in accordance with the journal's requirements.

Text
Abbreviations should be explained after their first use. In the case of many abbreviations, they should be listed separately before the "Introduction" section;
In the text, the cited source is indicated in square brackets by the number corresponding to its number in the list of references. Abbreviations of the names of cited sources and the number of authors are not allowed.
Physical, chemical, technical and mathematical terms, units of physical quantities and symbols should be generally accepted. Abbreviations of physical quantities must comply with the requirements of the International System of Units (SI)

Tables, Figures, Equations
Tables, figures and formulas should be numbered and given after reference to them in the text (notes are placed directly below the table/figure/graph). All abbreviations should be deciphered when first mentioned in the text.

Figures and graphics must be centered, text wrapping around the image is not allowed. Figures should be in BMP, JPG, PNG (300 dpi) formats.

Equations should be created in Equation Editor (MathType is not allowed), mathematical variables in the text according to formulas are typed in italics. All symbols should be described after the corresponding formula. 
Authors should use IEC 60027-1:1992. Letters symbols to be used in electrical technology - Part 1: General (https://webstore.iec.ch/en/publication/91) for designing manuscript.
All variables used in the formulas should be explained with the SI units.

 Articles that do not comply with these requirements are returned to the author without consideration.
The date of its receipt by the Editorial Board will be the date of review and submission of the article in accordance with the above requirements.